Commissioning is the step that turns an installed device into a working part of the building. In Della, the installer confirms the unit and brings the device online, and InSync checks the device against the design before it is tested and marked commissioned.

A device that is mounted and powered is not finished. It still needs to know where it belongs, which settings to run and who it serves. When each technician commissions their own way, small mistakes go unnoticed: a lock set to the wrong unit, a thermostat on the wrong policy, a camera covering the wrong area.
Commissioning confirms where the device belongs, applies its approved configuration and checks that it reports as expected. Each type of device receives something different. Access control receives its doors, schedules and the credentials it should accept. An EV charger receives its parking space and who is allowed to charge.
In Della, commissioning follows the same path for every device and is recorded against the building's design. InSync checks each device before it is tested and marked commissioned. The record carries forward through health checks, alerts, supported updates and replacement, for the life of the device.
Fewer surprises after handover, a building that works the way it was designed and a record the next technician can trust.
No. Installation puts the device in place. Commissioning makes it a working part of the building, assigned to the right place and running the right settings.
It starts at install. With InSync, the device stays checked against the design for its whole life, including when it is replaced.
Della InSync · Mission Installer · Building IoT and device management · Smart building integrator
Della OS walkthrough
Book a walkthrough and we'll show you how Della OS would run one of your properties, with your PMS and the hardware you already have.
Related